Bottle filler harness for the Enhanced EZH2O models LZS8WSLP, LZS8WSSP, LZSTL8WSLP, LZSTL8WSSP with a serial number 190424189 and above.
This wire harness bundle is located in the top (bottle filler cabinet) of your ezH2O combination fountain and bottle filler. There is another harness located in the cooler (fountain) portion of the unit. The model number for that is LKP-1000004547. The two are connected to each other where the basin meets the bottle filler cabinet.
This top harness then runs to the control board w/alphanumeric display, the LED filter status lights, and the bottle sensor. The top (bottle filler) is powered by two relay wires that are also part of this harness.
The two harnesses together allow for the control of the operating hours and temperature settings of the compressor (when to make it cold, and how cold to make it). They also connect the filter RFID tag reader to the control circuit (so that when the filter is changed, the filter usage count and status LEDs reset automatically).
NOTES:
If you have the earlier version of the enhanced bottle filler (serial number BELOW 190424189), use part: 1000001609.
If you have one of the original versions (LZS8WSLK, LZS8WSSK, LZSTL8WSLK, LZSTL8WSSK), use part: 1000004546.
