• Home
  • ASI (10-045224A-9) Automatic Paper Towel Dispenser, Roll Type, Surface Mount, Stainless Steel

ASI (10-045224A-9) Automatic Paper Towel Dispenser, Roll Type, Surface Mount, Stainless Steel

(0) No Reviews yet
$748.32
SKU: 10-045224A-9

IN STOCK

4 available for immediate shipment

Proximity sensing no-touch unit dispenses a pre-set length per cycle from 8″ or 9″ wide standard towel roll up to 800 ft. (244m) long and has stub roll capability for continuous dispensing.

Surface mounted with stainless steel collar.

Powered by 4 D-size batteries (not included).


Cover Material: 18 Gauge Type 304 Stainless Steel Alloy 18-8   
Mount: Wall / Surface   
Operation: Automatic (Hands-Free) Sensor Activated   
Power: 4 "D-Cell" Batteries (not included)   
Capacity: "One 8"" Dia., 8"" Wide Roll
One 4"" Dia., 8"" Wide Stub Roll"   
Locks: Yes, one tumbler   
Overall Dimensions: 30-1/2" Tall x 17-1/4" Wide x 10-1/4" Deep   
Net Weight: 26   
Shipping Dimensions: 32" Length x 19" Width x 12" Height   
Comments: Mount unit on wall using № 10 self-tapping screws (by others) through concealed mounting holes provided. For general utility install unit with top of towel dispenser opening between 49" [1245] and 56" [1422] AFF. Sensor ground wire must be connected inside cabinet   

Architectural Specifications:

   

Surface Mounted Automatic Roll Paper Towel Dispenser shall hold and dispense one 8" Dia. [Ø203] x 8" [203] wide standard towel roll up to 800 ft. (244m) long and one 8" [203] stub roll up to 4" Dia. [Ø102]. Automatic Touchless Roll Towel Dispenser shall be powered by four (4) D-size batteries (not supplied) and shall operate automatically to activate towel dispensing when hands are placed in sensor zone. Unit shall feed out a length of towel during each activation selected by owner by setting length, delay and paper saver switches. Unit shall have an internal towel cut-off bar. Cabinet and frame shall be fabricated of 22 gage type 304 stainless steel alloy 18-8 and towel dispenser door shall be 18 gage same grade. All exposed surfaces shall have satin finish protected by PVC film easily removed after installation. Door shall be attached to cabinet at side with a full-length 3/16" Dia. [Ø4,8] stainless steel multi-staked piano hinge and shall be held closed with a tumbler lock keyed alike to other ASI washroom equipment. Face trim shall be 1" [25] wide formed from one piece with no miters, welding or open seams and have 1/4" [6,4] square return to collar. Structural assembly of all components shall be of welded construction. Cabinet shall have no exposed fastening devices or spot-welded seams.



Ratings & Reviews

No reviews available

Be the first to Write a Review